You can forget at home you credit card but not your Moba!l Watchdog. As any Watchdog, it's probably the most effective remedy against the electromagnetic pollution. Actually Moba!l Watchdogs is available in two versions: Ether!c Pendant and Horus K-ring. The range of action of the Moba!l Watchdogs is few meters so it’s particularly useful when worn or anyway carried with you. It is possible that some highly sensitive people could feel a faint itch when the Watchdog is in contact with the skin, but the duration of this effect is short so don’t care about it, usually it happens when the Watchdog is strongly balancing the subtle energies which flow in our body.
Our products are all hand-made then they are unique and unrepeatable, just like you, so don't ask for Watchdogs perfectly similar to the ones showed in this website.
As for all our products, it follows the instructions to do them by yourself. We recommend maximum attention for who works indoor since the polyester resin is very volatile. We heartily suggest you to work outdoors and to use dungarees, gloves and, if needed, even glasses to protect eyes.
*We are not responsible for any incident which may be caused in the case you don't follow the instructions. Finally we remind you the high flammability of the resin during the catalysis.
How to make a Mob!l Watchdog
Requirements:
- Aluminium or silicon moulds for pudding
- Polyester resin
- Aluminium or Iron chippings
- A single headed crystal shard, quartz is fine.
- Copper wire, thick from 0.8 to 2mm and long 523mm
- Quartz Powder
- Trepan with a drill of 2mm
- Super Glue
- Any kind of holder for making a Key ring, a pendant
Shed the resin into the moulds ( 50% of their volume ) like shown in ( Fig.1 ) then add the resin catalyzer ingredient keeping to the instructions that usually are sited on the resin's gallipot.
Fig. 1
Fig. 2
Add some aluminium or Iron chippings into the mould and put the crystal into the center of the mould like in ( Fig. 2 ) then add some more resin and in case the mobius spiral that you just made ( Fig. 3 ).
At this point put into the mould more chipping and last but not least spill again resin and chipping until you totally fill the mould, finally wait for the catalysis of the resin to be completed.
Fig. 3
If you like to add a Mobius Double Spiral to the watchdog in construction, take the copper wire and coil it like in ( Fig. 4 ). then place your mobius spiral into the watchdog ( before catalysis is completed ) as shown in ( Fig. 5 ).
Fig. 4
Fig. 5
When the catalysis is finished ( wait at least 24 hours before removing the Watchdog from the mold ) you can create a pendant or a key ring. In any case you must pierce the artefact with a head of 2mm as shown in ( Fig. 6 ) then you have to insert the holder that you prefer into the hole you just made and finally you must fix it with super glue ( Fig. 7 ).
Fig. 6
Fig. 7