The classic TB style Watchdog, effective against electromagnetic pollution resulting from the resence of mobile phones antennas and other sources of electromagnetic waves like monitors mobile phones microwave owens and so on. Watchdogs aren't bulky and thanks to their original shapes they may also be used as ornaments for the house. The range of action is about a 3 rooms apartment. In the worst cases as for the people living in metropolis, we suggest you to install 4 Watchdogs, one for each corner of the house or the cardinal points.
Keep in mind that in every big city the average distance between a BTS antenna and the adjoining ones ( in a triangular network ) is about 100 metres, apart the ones skilfully hidden and disguised as fake trees tops, on the top of churches, into cemeteries or behind charts and the last fashion... close to nursery schools !!! In this way if the new children grow up side by side microwaves, it will be easier to subdue them with their young DNA damaged and the immune system so weak. They will be medicine addicted, always sick and frail.
As for all our products, it follows the instructions to do them by yourself. We recommend maximum attention for who works indoor since the polyester resin is very volatile. We heartily suggest you to work outdoors and to use dungarees, gloves and, if needed, even glasses to protect eyes.
*We are not responsible for any incident which may be caused in the case you don't follow the instructions. Finally we remind you the high flammability of the resin not yet catalyzed.
How to make a TB Watchdog
Requirements:
- Aluminium or silicon molds for pudding
- Polyester resin
- Aluminium or Iron chippings
- A single headed crystal shard, quartz is fine.
- Copper wire, thick from 0.8 to 2mm and long 523mm
- Quartz Powder
- Super Glue
Shed the resin into the molds ( 50% of their volume ) like shown in ( Fig.1 ) then add the resin catalyzer ingredient keeping to the instructions that usually are sited on the resin's gallipot.
Fig. 1
Fig. 2
Add some aluminium or Iron chippings into the mold and put the crystal into the center of the mold like in ( Fig. 2 ) then add some more resin and in case the mobius spiral that you just made ( Fig. 3 ).
At this point put into the mold more chipping and last but not least spill again resin and chipping unitl you totally fill the mold, finally wait for the catalysis of the resin to be completed.
Fig. 3
If you like to add a Mobius Double Sp!ral to the watchdog in construction, take the copper wire and coil it like in ( Fig. 4 ). then place your mobius sp!ral into the watchdog ( before catalysis is completed ) as shown in ( Fig. 5 ).
Fig. 4
Fig. 5